You can use 0.5mm wire (telephone wire?!) to connect surface mount device to a DIP socket. Take extreme care when unsoldering them, don't overheat IC and PCB traces, do not apply to much force. Motherboards usually employ a surface mounted type of SPI.Use following programming sequence: id, erase, write, read, compare data that you've read in the last step with the data you've programmed into device.If you're getting 0xffff something is wrong with your programmer, SPI device, or computer settings (like parallel port address and mode). Perform an id operation after connecting an SPI device, you should receive a valid JEDEC ID (not 0xffff).Configure parallel port in a Standard (unidirectional) mode, on address 0x378 (this is defined in parport_driver.h).See attachments for programmer's software source code. You may notice that verify mode is not provided, but you can easily verify a device by reading its content and comparing it to the original file ( diff is your friend). It will write exactly 2MiB of data, and expects the input file to have this size. write - writes content of a file to an empty (previously erased) SPI device.read - reads content of SPI, currently it reads exactly 2MiB of data (because SST25VF016B is 2MiB device, could be easily changed in the source code).id - reads JEDEC ID from the device, and be used to test that programmer is functioning correctly, and SPI flash is in working condition.It uses some sample SPI programming code provided by SST.įollowing modes of operation are supported: id, read, write, and erase. Programmer's software is written for Linux. See attachments for the schematics (EAGLE). You can find this voltage on an ATX power supply (orange wires) installed in your computer, or simply use a pair of AA batteries. The programmer requires a 3.3V power supply. The only (active) component in the programmer is a CD4049UB inverting buffer IC. PC's parallel port is used to control the programmer (I know that some recent motherboards don't have such a port, but I am sure that you still have some older system with such port around -). But I believe that only minor code modifications are required to add support for other types of SPI. The programmer's software supports only SST25VF016B devices, found on many Intels' motherboards. But yet it fully functional and allows user to read, write and erase SPI flash devices. I designed a very simple SPI flash programmer, that includes only one IC.

And in unfortunate case of failed BIOS upgrade, it's no longer possible to use good old 'hot swap' flash programming method, because SPI is not socketed. Many recent motherboards use SPI flash memory instead of regular (parallel) NOR flash devices.

Spi Serial Flash Programmer Schematic